L-016 1/10 Scale Racing Car Truck Body Shell Roof Bonnet Eagle Decal Mount Light

L-016 1/10 Scale Racing Car Truck Body Shell Roof Bonnet Eagle Decal Mount LightTo suit 1 10 scale models car or truck shells. Requires a thin long 19mm hole drilled and cut for the wires to feed through. Using the double sided tape included 1 small square attach the eagle decal to the body shell. Features a simple push button switch to change lighting modes. The lighting mode can be toggled by hittin the ch3 button on your remote for 3c remotes only. This set would be powered by the receiver any 27mhz 35mhz 40mhz AM FM or 2.

70mm Internal Diameter

Please check measurements below before ordering: 317mm long by 117mm wide

For 5 male and 5 female connector

198mm Long - 124mm Wide - 69mm High

Aluminium purple air filter

battery and charger etc please see our other items or contact us so we can direct you to the right listing

1 x manifold 30mm long - 1 x gasket (not pictured but included) - 1 x silicone joint 38mm (not pictured but included) - 1 x manifold spring (not pictured but included)

4ghz) which must be running by an esc or have a 6v DC input if using two servos for nitro models

Uncut and requires drilling so can be customised to fit other models

uk Notes: Will fit most nitro buggies including the Smartech / ACME / Hi Speed / BSD Models

Camber guage Theirs a space also to put any extra bits and bobs no tools in this space please see picture

If you require the 19mm depth starter please click here