PSM Hand brake (in line type) stainless lines and fittings kit for S13,S14 & FC (Not for ABS cars)

PSM Hand brake (in line type) stainless lines and fittings kit for S13,S14 & FC (Not for ABS cars)Listing is for: 1x Inline lines and fittings kit Includes: 2 44" lines with 3 female ends 1 3 male to 4 male 1 4 crush washer 1 3AN to 3 8 24 Inverted Flare 1 3 crush washer, 2 90* 3 Swivel Female x 3 Male 1 10mmx1. 0 I. F. female To 3 male 1 dash3 AN male to 10mm x 1. 0 male Male M10 to 3 male goes to the OEM master's rear brake output and 3 steel braided line (which connects to the inlet on the end of the wilwood cylinder) Female m10 to 3 male goes

One side of the black thread tube is M12

**Installation tip: If planning to run zero camber

75)  Mounting bolt pattern 6x10" 24-bolt pattern  High-pressure fuel pump connector 6-pin bulkhead connector  - Connector points x 6 (max 30 ampere / each *)  Pickup fuel pump connector 6 mm bolt connector  - Connector points x 3 (max 125 ampere / each *)  Length 295mm (13

adapted for the 90C series Air Jacks

The Racing 4M is a 4 point saloon harness with 3" wide shoulder and 2" wide lap straps with a waist load spreader pad for better comfort

Designed to be a direct replacement for the Original Equipment (OE) pads the Brembo sport pad comes with the exact same specification as the OE pad including (where applicable): fitted wear leads

But for those who prefer a remote fill

Ideally you will cut the outer threads on the S14 ITR to the length that both achieves toe alignment and also gives max thread overlap in the OTR hex turnbuckle

adjustable snapback

Part number SSE is sold separately

Fits the affordable AluCell fuel cells from Nuke Performance

right here