MACE TWIN GAUGE PILLAR POD TO SUIT HOLDEN STATESMAN WH WK WL

MACE TWIN GAUGE PILLAR POD TO SUIT HOLDEN STATESMAN WH WK WLIf you own a Holden from VT to VZ and are looking to add additional gauges to your vehicle then this gauge holder is for you! Key Features: Suitable for up to two 52mm gauges. Low profile design to minimise blind spots. Mounts directly over interior trim using 2 screws for fixture. Clean factory look. No visible wiring. Airbag compatible Retains factory grab handle. Designed and engineered in Australia. Gloss black with textured finish. Can be

If you own a Holden from VT to VZ and are looking to add additional gauges to your vehicle then this gauge holder is for you!

Key Features:

• Suitable for up to two 52mm gauges.
• Low profile design to minimise blind spots.
• Mounts directly over interior trim using 2 screws for fixture.
• Clean factory look.
• No visible wiring.
• Airbag compatible
• Retains factory grab handle.
• Designed and engineered in Australia.
• Gloss black with textured finish.
• Can be resprayed to match your vehicle's interior.

Contents:

• 1 X Pillar pod
• 1 X Instruction manual
• 2 X O-ring
• 2 X Rivet clip
• 2 X Cup spacer
• 2 X Gauge cup
• 2 X Stainless screw
• 2 X Stainless washer

Vehicle Fitment Guide

There are rules and regulations that cover the installation of aftermarket components in Australian road vehicles. As these rules differ from state to state, please check with your local transport authority for further information.

Note: The image is for illustrative purposes only.