Tone Guard Device - Compressor

Tone Guard Device - CompressorThe tone keeper is a six knob optical compressor based around the EQD Warden and lifts every slightly hit note right into your face. A compressor with so many features usually reserved for studio gear and work equally well on bass guitar. A built in charge pump brings the unit up to 18v while you only need 9v to power it but still get the maximum clean headroom and sustain without getting noisy at all, thanks to the opa2134. (This chip is a bit more

you can leave the toggle out and solder a jumper

When engaged

DIMENSION: Adds a slight slap-back at low levels

for the DIY builders

diodes out for more volume /headroom

you probably won’t find anything lower or more distorted than this

Renegade Smallboard 2

This board has been corrected and improved a couple of times

A deep rumble jolts the cabin as the main engines come up to full thrust

Pre-control knob replaces the Hi/Lo switch of the standard Pharaoh and adjusts the front-end saturation between tones with more headroom/less clipping and less headroom/more clipping

Four Internal Trimpot to regulate bias of the transistors

many different versions have been popping up all over the place