WoodOwl Countersink/Counterbore for #6 Wood Screw

WoodOwl Countersink/Counterbore for #6 Wood ScrewThis combination drill and countersink counterbore bit from WoodOwl drills the hole and creates the countersink or counterbore for a #6 wood screw, all in one step. The tapered bit acts as both a pilot bit and drill bit and is machined with elongated flutes for fast and clean chip clearance. Both the drill and countersink are hardened, sharpened and machined to very precise tolerances. The depth of the drill hole, countersink, and counterbore are

But for those that are looking for the absolute sharpest edge possible

Blade pitch of 55 degrees for superior results on hard

and 18 mm wide x 9 mm thick base

and when turned over it can also be used as a sharpening base

Note: Vice does come with 1/2" dog holes drilled in the top of the vice as seen in some of the photos/videos

5 mm wide base

and subtract 1° for blades that are 6

This chisel has a width of 3/4"

A lot of the product that is packaged and sold in North America as Camellia Oil contains up to 95% paraffin/mineral oil with small amounts of Camellia Oil added

The tang on the blade is approximately 5

000118") for the 300 mm (11

In both cases